instaling Serif Affinity Publisher 2.3.0.2165

then using opacity to get a similar effect just using the keyboard keys 0-9 I tend to avoid accumulation unless I need the jitter! and and opt for a solid brush. not finished yet! to consider the changes in the brush engine. It does not take too long but in the end the brushes work much better!.I had to update a lot of my brush sets. Thank you again I truly appreciate it! And thanks everyone else for their input as well

In regards to the spacing though, I've never noticed slowness but what would you recommend I set it to?

And yeah, I do unfortunately have quite a few brushes to go in and change now haha. I guess they must've changed how brush dynamics worked since I updated. I'm not sure if the brush engine was changed, if this is a bug, or if I'm missing something very obvious that I'm doing wrongĪny help would be greatly appreciated cause this has been incrediblyy Stuart, you're a legend, thanks so much! I set the accumulation from 100 to 0 in dynamics and from 50 to 100 in general and it's functioning as it did before now. I even exported the ones from AP1 to AP2 to make sure and they're still acting different So, the AP1 photos are how it's supposed to work and AP2 photos are how they're now working for some reason. I wasn't sure how to go back to the previous version I had to show the difference in behaviours, but I opened Affinity Photo 1, which I used before AP2, and used the same brush with the same exact settings (wet edges off, blend mode set to normal). I'm not too sure how to describe it but they all have the same settings as before but now the opacity is extremely light, even with pressing down hard on the tablet. After the update my brushes are all behaving differently than before the update.

(after not updating for several months, so can't remember which version I was on before).

Hey there, I just updated my Affinity Photo 2 software to 2.

Instaling Serif Affinity Publisher 2.3.0.2165